Quick Start¶
Setup the toolchain¶
Go to Tools > Toolchain > Install
Apio backend will be installed, and all its needed packages. This operation does not require Internet connection.
Setup the drivers¶
Connect your FPGA board and select Tools > Drivers > Enable. This operation requires administrator privileges.
Note
In Windows, an external application (Zadig) is launched to replace the existing FTDI driver of the Interface 0 by libusbK.
Upload a design¶
Go to Select > Board
Go to File > Examples > 1. Basic > 01. One LED
Then, you can verify, build or upload the project in Tools > Verify | Build | Upload.
Here is the FPGA board with the LED0 turned on.